P2/ Signpost

assembly instructions

- What you'll need -

-a good phillips screwdriver (preferably cordless electric)-
-something to drive a stake into the ground with-

Lay sign face up on a good, flat surface. Find side brackets included with kit, and align one against each side of sign (they're marked to indicate how they fit in relation to the sign). Being careful to get screws started straight, fasten brackets to sign with long deck screws (3 per side).

With posts face down, place sign/bracket assembly face down between them and fasten with 3/4" stainless screws, two per side (see photo on left).
Carefully rotate sign/bracket/posts assembly face up and put two more stainless screws into post on each side (see photo on right).

Place cardboard template on ground where sign is to be located. Drive aluminum stakes straight into ground thru slots in template
(see photo 1).
NOTE:  Crosspieces welded to stake are designed to hold post centered, and will break off if hit with a hammer

Slide sign/posts assembly down over aluminum stakes (see photo 2)

Tear away template. Tighten stainless bolts on back of posts (see photo 3).

Need Help? Call 800-632-3545 9:00-4:00est Mon-Fri.